Thanks everyone for your votes and to my family for putting up with my craziness...I think I should mention I made these rompers while participating in Summerfest, and it was pretty crazy because of the lack of sleep thing going on...but I am still very happy with how they turned out!
My nieces Brinlee and Brooklyn both wore them to their family reunion this week at Bear Lake and loved having them and also got lots of compliments.
From BEACH TOWEL to BEACH WOW! You are going to love these Beach Towel Rompers for all of your Beach Bash Parties this Summer!
Each Beach Towel Romper is made of a single towel and fits perfectly over your swim suit. Wear the Beach Romper to the Beach or to all of your Pool Parties this Summer.
There was even had enough towel left over to make a coordinating beach bag!

You guys coming to the BEACH PARTY??
TUTORIAL:
Depending on how tall your model is you should be able to get one romper out of one towel... **Sorry I was in a mad dash to get these made before Summerfest and then before a family reunion so the pictures were taken on my nieces ipod.**
STEP ONE -- Fold your towel in half and figure out the width needed for the romper. I wrapped it from armpit to armpit and added about 4 inches.
STEP TWO -- Cut the towel into a big rectangle, using your measurements.
STEP THREE -- The perfect thing about using towels is using the bottom of the towel to hem your leg holes, this saves lots of time!
Fold the towel with right sides facing each other and cut a slit directly into the middle, about 3 inches up. This will section your leg holes in half.
STEP FOUR -- Sew along the sides with 5/8" of an inch. To finish the edge you can either serge them or a zig zag stitch works just fine!! Next sew along the inner leg seams with 5/8" and finish seams, I actually double stitched this area because I was afraid of seams ripping.
STEP FIVE -- Try the romper on your model to assess how high the top band will need to be. Fold the top of the towel down and trim excess towel off. Double band over and create an elastic casing.
Step SIX -- Try the romper on your model again {at this point they may or may not be happy with you...} and find the waist on your model. Mark the area off and prepare to make an elastic waist casing... the best tutorial I direct you to for this is actually from
DANA at MADE from her cute
T-shirt Dress, it's step #8.
**Side note I didn't double up the band like DANA tutorial suggests, the towel would be too thick!! eek! I just hemmed the top and bottom and then proceeded to attach the material to the romper. (Thanks for the feedback on this!!)
STEP SEVEN -- After you get your waist banding on I added some straps just below the casing on both sides to create a halter look. The straps were 2 in x 18 in and sewn a few inches in from the armpits. (This step could be optional if you would prefer the strapless look over the halter look.)
Hope this helps you enjoy your Summer a little more, we finally got the sun to shine here in Utah so we will be using our lots this week!